As of now I'm an owner of the Flying Bear Ghost 5 3D printer and here I'd like to share all my findings about this printer - based on own experience as well as any resouces found over the Internet.
First of all - my first ever 3D print 🎉
My copy of this printer is based on the following hardware:
- Main board: MKS Robin Nano v1.2 with STM32F103VE6
- Stepper motor drivers: 2xTCM2208 v2.0(X + Y), 2xA4988 (Z + extruder)
- Stepper motors:
- X: 42HY40-1.8-31.5B
- Y: 42HY47-2-24
- Z: 42HY47-2-12
- E0: 42HY40-1.8-31.5B
Here is how the mainboard looked right after the purchase:
The pinout of the MKS Robin Nano v1.2 board is presented below in two variants:
