Skip to content

Prefilter for 433 MHz remotes (and similar protocolls) written for an attiny45

Notifications You must be signed in to change notification settings

pilight/pilight_firmware

 
 

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

43 Commits
 
 
 
 
 
 
 
 

Repository files navigation

pilight firmware

this is an rf receiver prefilter for pilight build with an ATTiny45 / 85. it prefilters the received signal to reduce the load for pilight (http://www.pilight.org). you be warned: this could potentionally damage your raspberry pi and also other hardware. i take no responsability for any damages! use at your own risk!

  1. Install avrgcc:

sudo apt-get install gcc-avr avr-libc
  1. Install modified avrdude:

wget http://project-downloads.drogon.net/files/avrdude_5.10-4_armhf.deb
wget http://project-downloads.drogon.net/files/avrdude-doc_5.10-4_all.deb
sudo dpkg -i avrdude_5.10-4_armhf.deb
sudo dpkg -i avrdude-doc_5.10-4_all.deb
  1. Calculate the MIN_PULSELENGTH and MAX_PULSELENGTH values

MIN_PULSELENGTH =  ( shortest expected pulse - 10% ) / 10
MAX_PULSELENGTH =  ( longest expected pulse + 10% ) / 10

the shortest expected pulse is the minimal base pulse-width of all your protocols
the longest expected pulse is the maximal base pulse-width of all your protocols multiplied by 34
  1. Compile and program ATTiny:

make all

Additional info:

###Calculate fuses: http://www.engbedded.com/fusecalc/

###Pinout:

I use this circuit without resistors. if you want you can even power the ATTiny with 3.3V, it works for 4 out 5 ATTiny's, but i think the timing is less accurate. schematic

Name Raspberry Pi V2 ATTiny45 433 Receiver
MOSI 19 5 -
MISO 21 6 -
SCK 23 7 -
RESET 24 1 -
PI_IN see pilight cfg 2 -
REC_OUT - 3 DATA_OUT

to change the pins create an .avrduderc file in your home directory containing (the numbering is wiringpi numbering!):

programmer
	id    = "gpio";
	desc  = "Use sysfs interface to bitbang GPIO lines";
	type  = gpio;
	reset = 8;
	sck   = 11;
	mosi  = 10;
	miso  = 9;
;

###ATTiny85

If you want to program an ATTiny85 add a parameter when calling make:

Make all type=t85

About

Prefilter for 433 MHz remotes (and similar protocolls) written for an attiny45

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • C 80.7%
  • Prolog 19.3%