Increase sample rate

To increase the sample rate above once per 18 seconds, one must remove
the gas estimate virtual sensors and only sample Temp/Pressure/Humidity/AQI

arduino-bsec-wifi.ino

@@ -319,15 +319,19 @@ void setup(void)
  BSEC_OUTPUT_RAW_PRESSURE,
  BSEC_OUTPUT_RAW_HUMIDITY,
  BSEC_OUTPUT_RAW_GAS,
+/*
  BSEC_OUTPUT_RAW_GAS_INDEX,
+*/
  BSEC_OUTPUT_SENSOR_HEAT_COMPENSATED_TEMPERATURE,
  BSEC_OUTPUT_SENSOR_HEAT_COMPENSATED_HUMIDITY,
  BSEC_OUTPUT_RUN_IN_STATUS,
  BSEC_OUTPUT_STABILIZATION_STATUS,
+/*
  BSEC_OUTPUT_GAS_ESTIMATE_1,
  BSEC_OUTPUT_GAS_ESTIMATE_2,
  BSEC_OUTPUT_GAS_ESTIMATE_3,
  BSEC_OUTPUT_GAS_ESTIMATE_4,
+*/
  BSEC_OUTPUT_IAQ,
  BSEC_OUTPUT_STATIC_IAQ,
  BSEC_OUTPUT_CO2_EQUIVALENT,
@@ -408,10 +412,12 @@ void setup(void)
  }
 
  /* Load the configuration string that stores information on how to classify the detected gas */
+/*
  if (!envSensor.setConfig(FieldAir_HandSanitizer_config))
  {
  checkBsecStatus (envSensor);
  }
+*/
 
  envSensor.setTemperatureOffset(temperatureOffset);
 
@@ -422,7 +428,7 @@ void setup(void)
  }
 
  /* Subscribe for the desired BSEC2 outputs */
- if (!envSensor.updateSubscription(sensorList, ARRAY_LEN(sensorList), BSEC_SAMPLE_RATE_SCAN))
+ if (!envSensor.updateSubscription(sensorList, ARRAY_LEN(sensorList), BSEC_SAMPLE_RATE_LP))
  {
  checkBsecStatus (envSensor);
  }
@@ -700,15 +706,14 @@ void newDataCallback(const bme68xData data, const bsecOutputs outputs, Bsec2 bse
  break;
  case BSEC_OUTPUT_RAW_GAS_INDEX:
  println("\tgas index = " + String(output.signal) + ", accuracy: " + String(output.accuracy));
- if(int(output.signal) == 9){
- updateDisplay();
- commitLast();
- }
  break;
  case BSEC_OUTPUT_SENSOR_HEAT_COMPENSATED_TEMPERATURE:
  lastOutput.comp_temp = output.signal * 9 / 5 + 32;
  lastOutput.comp_temp_c = output.signal;
  println("\tcompensated temperature = " + String(lastOutput.comp_temp) + "°F" + ", accuracy: " + String(output.accuracy));
+ // commit the measurements here
+ updateDisplay();
+ commitLast();
  break;
  case BSEC_OUTPUT_SENSOR_HEAT_COMPENSATED_HUMIDITY:
  println("\tcompensated humidity = " + String(output.signal) + "%" + ", accuracy: " + String(output.accuracy));