Add support for Terasic DE10-Nano

[menloparkinnovation]

I have the Terasic DE10-Nano working with Arduino blink and serial I/O.

A future pull request will contain mappings for the DE10-Nano on board Arduino headers. Right now I left the mappings to the switches and LED's.

[gornjas]

Is the change for DE0 board necessary for getting DE10 to work?

[menloparkinnovation]

No it is not. I just noticed in the signal mappings for serial and the instructions I read did not match the pins. I moved the signals back to the 2x13 header are originally documented. You can leave that change out if you want the default RS232 signals on the 2x20 GPIO pin headers. I will working on adding mappings for the GPIO to the Arduino headers and updating the Arduino add-in. I will send that along in another pull request when I am done. Does the RISC-V work? I am in the middle of exploring it right now. Thanks, JohnR

…

On Wed, Feb 13, 2019 at 2:06 AM Marko Zec ***@***.***> wrote: Is the change for DE0 board necessary for getting DE10 to work? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#84 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AHM62HTV9AhEHFrtsLL5YBgReiSmhROlks5vM-ORgaJpZM4a1oAu> .

[menloparkinnovation]

Hi, I have RISC-V working on the DE10-Nano. I have also mapped the Arduino headers on the DE10-Nano to allow use of Arduino shields. I have also re-configured the project to use a common include for the signals, and you can now select various FPGA builds for both MIPS + RISCV with 32k, 64k, 128k, or 512k BRAM options as the FPGA on the DE10-Nano has 5+ MB of block rams. I will send a separate pull request when I get the Arduino integration changes done. On Wed, Feb 13, 2019 at 9:02 AM John Richardson < [email protected]> wrote:

…

No it is not. I just noticed in the signal mappings for serial and the instructions I read did not match the pins. I moved the signals back to the 2x13 header are originally documented. You can leave that change out if you want the default RS232 signals on the 2x20 GPIO pin headers. I will working on adding mappings for the GPIO to the Arduino headers and updating the Arduino add-in. I will send that along in another pull request when I am done. Does the RISC-V work? I am in the middle of exploring it right now. Thanks, JohnR On Wed, Feb 13, 2019 at 2:06 AM Marko Zec ***@***.***> wrote: > Is the change for DE0 board necessary for getting DE10 to work? > > — > You are receiving this because you authored the thread. > Reply to this email directly, view it on GitHub > <#84 (comment)>, or mute > the thread > <https://github.com/notifications/unsubscribe-auth/AHM62HTV9AhEHFrtsLL5YBgReiSmhROlks5vM-ORgaJpZM4a1oAu> > . >