NodeMCU DHT Case

A simple 3d printable case for NodeMCU board plus a DHT22 temperature and humidity sensor. It is licensed under GPL-3.0-or-later license.

Introduction

This case was designed considering NodeMCU Amica ESP-8266 boards in mind, connected to a DHT22 temperature and humidity sensor.

Source code

OpenSCAD source code can be found under src directory. It was written to be fully customizable and it can be adapted to other boards and sensors as well.

Debug mode

In order to validate the design it is possible to enable a debug mode inside OpenSCAD by setting DEBUG_MODE = 1 inside the source files. This will simulate the actual position of the screws in order to let you to double check if their position is what you expect.