XPRA Disable webp

[netwebdave]

Hi @posquit0 - found your XPRA config @ https://github.com/posquit0/dotfiles/blob/master/X/.xpra/xpra.conf which has been helpful. Thank you.

I am trying to disable the webp/pillow errors when I attach to an xpra display as I do not want to decode using Pillow. I found XPRA_WEBP_PILLOW option in the below link. I tried to add it to the xpra.conf file but am not sure of the syntax or even if this is the correct file/option. In xpra.conf, I used XPRA_WEBP_PILLOW=0. I also tried XPRA_USE_PIL. I also tried to set these as environmental variables (no joy). Would prefer they be in a config file if possible.

https://xpra.org/trac/wiki/Usage/EnvironmentOptions

I get the error: "UserWarning: image file could not be identified because WEBP support not installed". Just a note, I am in an environment where I cannot install WEBP.

Any help is appreciated.

[AhsenBaig]

Would be better to post this as an issue on that repository than ama section.
🐛 Bugs & feature requests should be opened on the relevant issue tracker.

[netwebdave]

Thx - at this point, I found workarounds for all my XPRA issues. Have a great day,

…

On Wed, Oct 5, 2022 at 11:35 AM Ahsen Baig ***@***.***> wrote: Would be better to post this as an issue on that repository than ama section. 🐛 Bugs & feature requests should be opened on the relevant issue tracker. — Reply to this email directly, view it on GitHub <#23 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AKT5HEKFNAUEEKIWJPBLDELWBWU4TANCNFSM5QWOZDIA> . You are receiving this because you authored the thread.Message ID: ***@***.***>