Skip to content

Latest commit

 

History

History
25 lines (18 loc) · 1.82 KB

linux-raid.md

File metadata and controls

25 lines (18 loc) · 1.82 KB
Raw

Linux/Ubuntu - Commands for making a RAID array

Digital Ocean has a fantastic guide for doing this with mdadm, the Linux RAID utility. Read it.

  1. lsblk -o NAME,SIZE,FSTYPE,TYPE,MOUNTPOINT (shows you what's going on with your computer's hard drives). Output will look something like this - this shows three drives. sda and sdb are identical unformatted 4TB HDs while sdc is a 128GB SSD with an Ubuntu bootable partition and a swap space setup for when memory runs low):
NAME     SIZE FSTYPE TYPE MOUNTPOINT
sda      3.7T        disk
sdb      3.7T        disk
sdc    119.2G        disk
├─sdc1   512M vfat   part /boot/efi
├─sdc2 102.9G ext4   part /
└─sdc3  15.9G swap   part [SWAP]

  1. sudo mdadm --create --verbose /dev/md0 --level=1 --raid-devices=2 /dev/sda /dev/sdb (Assuming the above drive setup, this command uses Linux's mdadm RAID creation utility to create an array. Here we are creating a RAID1 array with the --create flag, which means each byte saved to the array gets saved to each disk which creates a backup. You set the type of RAID array you want with the --level=1 flag, which indicates a RAID1 array. We're striping two drives, so --raid-devices=2 flag is set to 2. /dev/sda /dev/sdb describes the locations of the two drives we determined with the lsblk command.

  2. cat /proc/mdstat (this command shows you where your striping process is at - this can take hours depending on the size of your drives. With 4TB 5400RPM SATA3 drives, this took about 8 hours for me).

  3. sudo mdadm --detail --scan (shows you what's going on with your RAID array). Output looks like this:

ARRAY /dev/md/array-name metadata=1.2 name=server-name:array-name UUID=big:alphanumberic:string:here