-
When I tried booting from a vm, I can see the following:
But when I boot into a physical machine, my log stops at
Is there a config relating to this ? Thank you! |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
At this stage iPXE has told firmware to execute the kernel, and the kernel has started, as seen by the EFI stub message from the kernel. You need to debug the kernel, not iPXE. Consider reducing your command line as much as possible, also remove the initrd until you get any output from the kernel. |
Beta Was this translation helpful? Give feedback.
Thank you!
After doing some researches, this is related to some console settings.
I added
console=tty0
on the kernel parameter to print the kernel logs successfully.