-
Notifications
You must be signed in to change notification settings - Fork 1
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
craftbot #3
Comments
I should change it to 24V, a 24V Meanwell PSU is not expensive ;-) |
So the steppermotor too or they work with 24 vlots
…On Sat, 18 May 2024, 19:17 askmurphy, ***@***.***> wrote:
I should change it to 24V, a 24V Meanwell PSU is not expensive ;-)
—
Reply to this email directly, view it on GitHub
<#3 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AENFQ2MVFLT4U2KFWFFXX3DZC4MDFAVCNFSM6AAAAABH5AVZRGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCMJYG4ZTAOBZGQ>
.
You are receiving this because you authored the thread.Message ID:
<askmurphy/My-extreme-modded-Craftbot-3D-printer/issues/3/2118730894@
github.com>
|
Steppermotors are powered via the stepperdrivers, so you can use them. Check this: https://youtu.be/KM-5PYfRlso?si=oHFSL8abmyR35G41 |
what the pi for cant i just use usb to connect pi so i can use octo print or not thanks |
[email protected] email me pls |
Dp you have a new 3D-printer board already? If not: there are better boards available now. |
Not yet thanks .
…On Sun, 19 May 2024, 02:44 askmurphy, ***@***.***> wrote:
Dp you have a new 3D-printer board already?
If not: there are better boards available now.
—
Reply to this email directly, view it on GitHub
<#3 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AENFQ2KELTCMXKHBPD76IP3ZC6ANJAVCNFSM6AAAAABH5AVZRGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCMJYHA3TMNZTGM>
.
You are receiving this because you authored the thread.Message ID:
<askmurphy/My-extreme-modded-Craftbot-3D-printer/issues/3/2118876733@
github.com>
|
Maybe you can join discord: |
Nice board: €42,42 | Mellow Gloomy Fly Rrf E3 Pro V3.0 Wifi 1.6 M/s 32Bit controller board TMC2209 |
This is board has more options: Mellow High-Speed Super♾️ Pro Board 3 + 5 Hv 8 As 32Bit 550Mhz 2Oz Pcb for Uart Spi 3D Printer rrf/Klipper support Canbus I used the first board in my Ender5, |
i have the first one 12 volts and the ribbon one craftbot plus so cant with the ribbon one do i need to change to 24 volts or not
The text was updated successfully, but these errors were encountered: