Moes 2 gang zigbee 3 dimmer switch MS-105BZ not being fully recognised by Tasmota #21265
Unanswered
jpadie
asked this question in
Support request
Replies: 2 comments 2 replies
-
@s-hadinger posted as requested. |
Beta Was this translation helpful? Give feedback.
2 replies
-
@s-hadinger I should have some free desk time this week and wondered if you could share your approach to adding support for tuya type modules in tasmota's ZigBee implementation so that I could start having a go? |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
PROBLEM DESCRIPTION
A clear and concise description of what the problem is.
Pairing between tasmota zigbee bridge pro on a sonoff zigbee bridge pro and the MS105BZ works ok. pairing is effected by 10 slow presses on a rocker switch connected to the switch terminals of the modules.
however tasmota seems to see only one gang and control of either is not assured (not had much luck yet).
discussion on Discord moved to github at Stephan's request.
REQUESTED INFORMATION
Make sure your have performed every step and checked the applicable boxes before submitting your issue. Thank you!
Backlog Template; Module; GPIO 255
:Backlog Rule1; Rule2; Rule3
:Status 0
:weblog
to 4 and then, when you experience your issue, provide the output of the Console log:TO REPRODUCE
Steps to reproduce the behavior:
pair module MS-105BZ to tasmota.
EXPECTED BEHAVIOUR
A clear and concise description of what you expected to happen.
Expectation is that on/off and dim commands will be available for each gang of the module separately.
SCREENSHOTS
If applicable, add screenshots to help explain your problem.
ADDITIONAL CONTEXT
Add any other context about the problem here.
discord input from Stephan follows
At first glance, it is unfortunately a Tuya zigbee device. Tuya invented their own protocol over Zigbee and does not follow the Zigbee standards. Let me check
Based on Zigbee2MQTT your device signature is MS-105B not MS-105Z
With a zigbee plugin you should be able to see the first gang. But for the second, I'm afraid it will need to Berry code for this. It's actually a good use case for this. Can you please open a Github discussion instead of Discord? It's easier to follow-up
JPADIE response: looking at the z2m site, the version that I have is physically similar to both the 105B and 105Z. the case marking is 105BZ and the power rating is 2x100w. clicking on the 105B image on the z2m site takes the viewer to a completely different module (https://www.zigbee2mqtt.io/devices/TS0601_dimmer_2.html). perhaps similar underneath though (given the ts0601 identifier). the pairing instructions given for each of the 105B and 105Z are different and those for the 105Z work on the module I have. this page (https://zigbee.blakadder.com/Moes_MS-105B.html) suggests the module is confirmed to work with tasmota, which suggests that it is not the same as the MS-105B despite the identical Manufacturer designation.
activity logs.txt
pairing logs.txt
(Please, remember to close the issue when the problem has been addressed)
Beta Was this translation helpful? Give feedback.
All reactions