We read every piece of feedback, and take your input very seriously.
To see all available qualifiers, see our documentation.
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
HI
https://github.com/YahboomTechnology/Superbit-expansion-board/tree/master/5.Sensor%20course/08.Ultrasonic%20sensor/2.Ultrasonic%20ranging
In the Preparation section you show the sensor connected to .... Trig - P1 Echo = P2
but then in Section 5 you say to set the ultrasonicpin to ....
Trig = P0 ECHO = P1
Very confusing for beginners!!!
Please alter so that BOTH sections use / show the same pin configuration
The text was updated successfully, but these errors were encountered:
No branches or pull requests
HI
https://github.com/YahboomTechnology/Superbit-expansion-board/tree/master/5.Sensor%20course/08.Ultrasonic%20sensor/2.Ultrasonic%20ranging
In the Preparation section you show the sensor connected to ....
Trig - P1
Echo = P2
but then in Section 5 you say to set the ultrasonicpin to ....
Trig = P0
ECHO = P1
Very confusing for beginners!!!
Please alter so that BOTH sections use / show the same pin configuration
The text was updated successfully, but these errors were encountered: