You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
As comment in config says X, Y, and Z homing will always be done in spreadCycle mode. But this mode is on until second move after Z probing completed, producing gross sound. It means that move from end bump to center and probably one more is done in spreadCycle.
20240331_165827_edit.mp4
Bug Timeline
No response
Expected behavior
No response
Actual behavior
No response
Steps to Reproduce
No response
Version of Marlin Firmware
Latest bugfix-2.1.x
Printer model
No response
Electronics
BTT SKR-3 + TMC2209
LCD/Controller
No response
Other add-ons
No response
Bed Leveling
None
Your Slicer
None
Host Software
None
Don't forget to include
A ZIP file containing your Configuration.h and Configuration_adv.h.
Did you test the latest
bugfix-2.1.x
code?Yes, and the problem still exists.
Bug Description
As comment in config says
X, Y, and Z homing will always be done in spreadCycle mode.
But this mode is on until second move after Z probing completed, producing gross sound. It means that move from end bump to center and probably one more is done in spreadCycle.20240331_165827_edit.mp4
Bug Timeline
No response
Expected behavior
No response
Actual behavior
No response
Steps to Reproduce
No response
Version of Marlin Firmware
Latest bugfix-2.1.x
Printer model
No response
Electronics
BTT SKR-3 + TMC2209
LCD/Controller
No response
Other add-ons
No response
Bed Leveling
None
Your Slicer
None
Host Software
None
Don't forget to include
Configuration.h
andConfiguration_adv.h
.Additional information & file uploads
Config.zip
The text was updated successfully, but these errors were encountered: