You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
For any button click on my AC Remote, there are multiple outputs. And the protocol is Unknown, I'm not sure if I should be getting multiple set of outputs, for a single button click and how to transmit back to the AC.
ReceiveDemo output
Received noise or an unknown (or not yet enabled) protocol
rawData[2]:
-3276750
+ 600
Sum: 600
Received noise or an unknown (or not yet enabled) protocol
rawData[2]:
-17650
+3050
Sum: 3050
Protocol=PulseDistance Repeat gap=8900us
Space of 8900 us between two detected transmission is smaller than the minimal gap of 15000 us known for implemented protocols like NEC, Sony, RC% etc..
But it can be OK for some yet unsupported protocols, and especially for repeats.
If you get unexpected results, try to increase the RECORD_GAP_MICROS in IRremote.h.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Version/revision of the library used
4.3.1
Environment
Board : Arduino Uno Compatible Board with a ATMEGA328P chip.
IDE : Arduino IDE
AC : AR18CY3YATA : https://www.samsung.com/in/air-conditioners/split-ac/ar9500t-ar18cy3yatanna/
Remote : Samsung AC Remote, D896 25318J
Issue
For any button click on my AC Remote, there are multiple outputs. And the protocol is Unknown, I'm not sure if I should be getting multiple set of outputs, for a single button click and how to transmit back to the AC.
ReceiveDemo output
I have also attached the output of ReceiveDump.
ReceiveDumpOutput.txt
Example code used
ReceiveDemo
ReceiveDump
Beta Was this translation helpful? Give feedback.
All reactions